|
PRESS BRAKES CNC DENER
STANDARD CHARACTERISTICS:
ELGO CONTROLLER
Full steel body made from rigid material
Honed and chrome covered cylinder
Accurate storke system controlled by NC controller
Accurate back guage system controlled by NC controller
Standard X-Y axis
Back guage systems with lama systems
Command opportunity pedal systems
Standard 380 V and 3 phase and grounding
Manual, Automatic or semi-automatic mode
Ensuring safety working environment with backand rear guard doors
Hardened and grinded standard punch and die
Section punch clamping systyem
Bending line illumination
2 front supports with nail in T slots and sheet slider balls on the surface.
TECHNICAL FEATURES
There are 200 address lines which can be programmed.
Absolute positining mode
Incremental positioning in forward and backward direction
Tool offset compensation in incremental mode
Operation in program mode
Operation in single position mode
Position reach output
Inch/Metric selection
Flexible multiplier for encoder calibration
Datum pre-set
Automatic retract
Tolerance window blanking
Encoder and driver failure detection
Maximum Encoder frequency 20khz
Memory on power down of actual position program
|
